FK-1150 Installation Guide
- Unplug and place the printer on a flat surface and remove the cassette tray
- Open the back cover and look for the two clip holding the rear right cover on, pull the bottom out and the top comes off automatically.
- Grab the rear left cover here and pull off, it comes off easily.
- Grab the rear cover here and pull to the left, it does require a TINY bit of force.
- Next move to the panel and remove these two screws with a Phillips head (KEEP WITH COVER)
- Once all the cover are removed the back of the printer should look like this (Depending on the model)
- Move to this section of the printer where the plugs are, the bottom white plug easily comes off when you pull it away from the printer.
- The top white plug may require you to use a small flat head screwdriver in the place shown and VERY GENTLY.
- Once the cables are unplugged, remove these 4 screws (KEEP ASIDE)
- After you have removed the 4 screws, hold the flap of the fuser unit as shown below, however use both hands on both sides and gently pull it toward you.
- When installing the new fuser unit, hold it by the top and bottom of the metal plates and slide in, it will require a little jiggling, but you want to get the metal plates flush with the frame and then screw it back in.
- NOTE: IF YOU PUSH TOO HARD IT CAN BREAK THE GEAR IN THE PRINTER
- When plugging that cable back, make sure they are like the ones shown in step 7, I needed use a small flat head to push the thin and wide plug back as shown below, ONLY PRESS ON THE PLASTIC.
- Once the cable a back in place, do steps 5 -2 in the reverse of how you did then before, turn the printer on and test that it is working as intended.